11
Spa Bladder Inflation.
7.1 Open the air valve (a) on the bladder. Insert the inflation hose (b)
into the valve.
7.2 Press the Bubble button to inflate until it is firm to touch
but not hard.
7.3 Press the Bubble button again to stop inflation. Disconnect
the inflation hose from the air blower outlet and the valve
7.4 Replace the air valve cap (c) back on the control panel. Close
and recess the inflation valve (a).
7.
7
Water level must reach the MIN water line but not exceed the MAX. line to avoid pump failure.
Never pour water with a temperature higher than 42°C(108°F) into the spa directly.
To avoid control system failure, do not operate the spa until water reaches the MIN. line.
Spa Deflation.
8.1 Unscrew the air valve cap on the spa pool to deflate the spa.
8.2 Once the deflation is completed, replace the cap back.
Spa Bladder Deflation.
9.1 Pull the valve cap out and squeeze the valve at its base until deflated.
9.2 Close and recess the valve back.
Water Filling
10.1 Check the spa liner is at the selected area and point the drain
valve toward a suitable draining area before inflation.
10.2 Fill the spa tub with fresh water to a level between MINIMUM and
MAXIMUM line marked on the inside of the spa wall.
Do not over fill the spa. It is recommended to fill the spa with
lukewarm water for quick heating and energy saving.
WARNING:
10.3 After water filling, double check the spa pool air pressure to makes sure the manometer points out the Green section.
10.4 Place the inflated air bladder and the zipper spa cover over the spa tub, and make sure the spa cover zipper are closed
and lock the cover by the digital lock in the accessory pack.
IMPORTANT:
Inspect the spa pressure regularly for leak, premature wear or deterioration.
Check and wax the zipper regularly, to make it smooth for operation and avoid splits.
8.
9.
10.
(a)
(b)
(c)
10
10.4
The cap is designed to be screwed on and off. Never exert force as this could cause the compete internal inflation
system of the valve to come loose.
If over inflated, remove the inflation hose from the spa air valve side, screw the valve cap to release some air and stop
until the manometer points to the right color section.
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels